Talk:Temperature Measurement: Difference between revisions

From Saltwiki
Jump to navigation Jump to search
(Created page with "Autor: Hans-Jürgen Schwarz <br> <br> zurück zu Messung_klimatischer_Parameter <br> == Overview of the chapter on tem...")
 
(Blanked the page)
 
(6 intermediate revisions by 2 users not shown)
Line 1: Line 1:
Autor: [[Benutzer:Hschwarz|Hans-Jürgen Schwarz]]
<br>
<br> zurück zu [[Messung klimatischer Parameter|Messung_klimatischer_Parameter]] <br>


== Overview of the chapter on temperature measurement ==
*[[Contact temperature measurement]]
**[[Berührende Temperaturmessung#Fl.C3.BCssigkeitsthermometer|Liquid thermometer]]
**[[Berührende Temperaturmessung#Widerstandsthermometer|Resistance temperature detectors (RTD)]]
**[[Berührende Temperaturmessung#Thermoelemente|Thermocouples]]
**[[Berührende Temperaturmessung#Bimetallthermometer|Bimetal thermometer]]
**[[Berührende Temperaturmessung#Quarz-Thermometer|Quarz-thermometer]]
*[[Non-contact temperature measurement]]
**[[Berührungslose Temperaturmessung#Infrared thermometer]]
**[[Berührungslose Temperaturmessung#Infrarotkamera|Infrared camera]]
*[[Selection of a suitable temperature sensor]]
**[[Auswahl des geeigneten Temperaturfühlers#Zeitverhalten|Timing]]
**[[Auswahl des geeigneten Temperaturfühlers#Messung_von_Oberfl.C3.A4chentemperaturen|Measurement of surface temperatures]]
<br>
== Introduction ==
In addition to properties such as mass, volume, each body also has thermal values that give information about their thermal state.
Temperature is the physical and objective term that classifies the subjective feeling of cold and warm into an absolute scale.
Temperatures are measured with thermometers. Thermometers take advantage of the specific temperature-dependent properties of  materials (e.g. volume). For laying down scales and for the calibration of thermometers, temperature fixed points are necessary. The most frequently used two fixed points are:
#Melting ice =273.15 K (0ºC, 32ºF) at standard pressure (1.013 bar)
#Water at boiling point at standard pressure
<br>
If these fixed points are assigned to specific temperature values and the difference is divided, different temperature scales are obtained. The following table shows the correlation between the most important scales:
<br clear="all">
{|border="2" cellspacing="0" cellpadding="4" width="55%" align="left" class="wikitable"
|+''Tabelle 1: Die Temperaturskalen''                   
|-
|bgcolor = "#F0F0F0" | '''Scale'''
|bgcolor = "#F0F0F0" | '''Celsius'''
|bgcolor = "#F0F0F0" | '''Kelvin'''
|bgcolor = "#F0F0F0" | '''Fahrenheit'''
|bgcolor = "#F0F0F0" | '''Reaumur'''
|-
|bgcolor = "#F7F7F7" | '''Symbol'''
|bgcolor = "#FFFFEO" | <math>\vartheta</math>
|bgcolor = "#FFFFEO" | T
|bgcolor = "#FFFFEO" | tF
|bgcolor = "#FFFFEO" | tR
|-
|bgcolor = "#F7F7F7"| '''Unit'''
|bgcolor = "#FFFFEO" | ºC
|bgcolor = "#FFFFEO" | K
|bgcolor = "#FFFFEO" | ºF
|bgcolor = "#FFFFEO" | ºR
|-
|bgcolor = "#F7F7F7" | '''1. FP*'''<br>'''2. FP'''<br>'''Division'''
|bgcolor = "#FFFFEO" | 0<br>100<br>100
|bgcolor = "#FFFFEO" | 273.15<br>373.15<br>100
|bgcolor = "#FFFFEO" | 32<br>212<br>180
|bgcolor = "#FFFFEO" | 0<br>80<br>80
|-
|bgcolor = "#F7F7F7" | '''Use'''
|bgcolor = "#FFFFEO" | Europe
|bgcolor = "#FFFFEO" | Science
|bgcolor = "#FFFFEO" | USA
|bgcolor = "#FFFFEO" | France<br>(Outdated)
|}
<br clear="all">
*FP – Fixed Point
The subdivision of the individual scales and their reciprocal conversion occurs linearly. The Kelvin scale is based on the increase in pressure of an ideal gas, the other scales are based on the increase in volume of mercury. Celsius and Kelvin are equal for temperature differences but not for absolute values.
All temperature scales were replaced in 1990 by the international temperature scale ITS-90. This has resulted in the Celsius scale not being based on the boiling point of water at 1013.25 mbar= 100ºC. The consequence is, that the boiling point of water is now 99.974ºC at standard pressure.
The various temperature measuring methods can be roughly divided into mechanical and electronic ones. The best known mechanical methods are based on the expansion of the sensor i.e. bimetallic strips, liquid thermometers (e.g. mercury, alcohol inside a capillary tube) and gas thermometers.
Today, electronic and optical temperature sensors are used most widely. In electronic sensors mostly the change in electric resistance is evaluated through temperature (resistance thermometers such as PT-100, NTC- elements).
Optical sensors are widely used for the remote determination of temperatures and for moving hot building components (IR thermography).
[[Category:Schwarz,Hans-Jürgen]] [[Category:Temperaturmessung]] [[Category:Review]] [[Category:Übersicht]]
[[User:SLeithaeuser|SLeithaeuser]] 22:42, 23 September 2012 (CEST)

Latest revision as of 16:38, 5 December 2012

Retrieved from "https://saltwiki.net/index.php?title=Talk:Temperature_Measurement&oldid=5237"