Architectural Ceramics

Author: Hans-Jürgen Schwarz
English Translation by Sandra Leithäuser
Back to Decay Pattern

Abstract

Typical deterioration patterns for architectural ceramics are discussed and explained.

Decay patterns of architectural ceramics

Deterioration of brickwork

Salt-induced damage to bricks is common.

Damage to bricks can appear as follows:

Glazed architectural ceramics

The glaze on building ceramics prevents the transport of moisture and salts. Often however, the glaze shows "crazing" (a fine network of fissures or cracks) allowing moisture transport through it. And therefore, if salts are present, they will crystallize around these fissures as well as below the glazing around them, leading to their spalling.

Some examples of salt-contaminated architectural ceramics are shown here.

Flaking

• Decay pattern on a brick of the St. Jakobi Church in Perleberg
• 

  Figure 1: The scaling surface of a damaged brick, caused by crystallizing salts.

• 

  Figure 2: Photo micrograph of a thin section in polarized light. The gray parallel crystals are gypsum.

• 

  Figure 3: Photo micrograph as Fig 2 with crossed polars. It is clearly visible that the gypsum is causing the damage to the brick, however, it also serves as filler, holding the flaking pieces in place. If the gypsum would be removed, the original surface of the brick would be lost.

Weathering

• Damage to a building in Lüneburg
• 

  Figure 4: Salts causing damage to a molded brick

• 

  Figure 5: Salt action under a coat of paint resulting in its detachment and disintegration of the brick.

Efflorescences

• Efflorescences on architectural ceramics
• 

  Figure 6: Salt efflorescence on a flagstone.

• 

  Figure 7: Carbonate salts incrustation on a pillar resulting from the leaching of cement slurry injections.

• 

  Figure 8: Crystallizing salts accentuate the crazing of a glazed tile. Gradually, the salts will induce the glaze to spall off.

crystallization of a dissolved salt