Micro-chemical test for sulfate

Author: Christine Bläuer

back to Micro-chemical testing

Micro-chemical test for sulfate (SO₄^2-)

More information about the necessary equipment and materials see article Micro-chemistry.

Procedure

SO^42- test using calcium chloride solution

Add a drop of CaCl₂ solution (1% aqueous solution) to the test drop. Heat the drop gently until the edge of the drop starts to dry (do not dry completely!). Observe the crystals forming at the fringe under the microscope at a magnification of about 100x. When the solution contains sulfate, gypsum crystals form that can easily be recognized by their short and twinned shape (image 1).

image 1: Short, typically twinned gypsum crystals at the border of the drying test drop.

Samples containing both calcium and sulfate

In solutions containing both Ca²⁺ and SO₄^2-, gypsum crystals can be observed at the fringe of a test drop while drying. These have very distinct shapes if the drop was previously acidified with 2M hydrochloric acid or 2 M nitric acid respectively. When comparing the amount of gypsum formed in drops with or without addition of calcium chloride solution respectively, it can be estimated if the salt solution contains the same amount of calcium and sulfate or if one of the two ions is predominant. For this purpose, the test has to be repeated with known salt mixtures.

SO^42- test using silver nitrate solution

The drop to be tested is acidified with very little diluted nitric acid and then a drop of silver nitrate solution is added. If sulfate is present typical silver sulfate crystals are formed.

SO^42- test using barium chloride solution

The drop to be tested is acidified with a very little drop of diluted hydrochloric acid (2M) and then a drop of barium chloride solution is added. If sulfate is present, finely crystalline white barium sulfate (BaSO₄) precipitates out.

Literature

There were no citations found in the article.